![]() NOTE: Connecting the chassis power-up harness to the DC POWER TEST plug will power the DC chassis circuit. When battery power is connected successfully, the SmartLink status LED will blink on once.ĩ923311 - 2010-2012 PRO-RIDE RUSH/Switchback/RMK Service Manual NOTE: An internal relay within the harness prevents reverse polarity damage in the event the alligator clamps are connected to the battery incorrectly. Connect the chassis power- up harness to the ECU POWER connector. Remove the protective cap from the Digital Wrench™ connector (A) and then connect the Vehicle Interface Cable to the diagnostic connector.Ĭonnect the chassis power-up harness to a fully charged 12VDC battery. The diagnostic/power connectors are located behind the left engine compartment door.Īssemble the SmartLink Module and attach the PC Interface Cable to your PC/laptop. ĭigital Wrench™ - Diagnostic / Power Connectors If you experience problems connecting to a vehicle or any Digital Wrench™ related problem, visit the Digital Wrench™ Knowledge Base for the most current troubleshooting information, FAQs, downloads and software updates at.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |